LG 55UR80 0PSB Series Service Manual page 24

ASSEMBLY / DISASSEMBLY GUIDE (MODULE)
■ LCM Service Assembly / Disassembly Guide
(1) LCM status
- Panel face on flat surface LCM located to floor (such as a table where the entire outside of C/Top can be supported)
※ If there's a T-con board, remove the T-con board and FFC cable. (Only for application models)
- Disassemble 2 screws on the T-con board
- Open the latch of the FFC Connector to remove the FFC cable (same left/right method).
M3 screws 2ea
(2) Disassemble SPCB Cover shield screws 5ea. (Use General Screw Driver)
(3) Disassemble the screw, and then move each SPCB cover field L/R upward to disassemble it.
- 24 -
Copyright © LG Electronics Inc. All rights reserved.
Only for training and service purposes.