Signal Tones - Miele G 5481 SCVi SL Operating Instructions Manual

Signal tones

A sequence of signal tones will sound
at the end of the programme or if there
is a fault.
The signal tones at the end of a
programme and the alarm tone in the
event of a fault will sound 4 times at
intervals with a short pause between
each set.
You can activate or deactivate the
signal tone that sounds at the end of a
programme if you wish.
The alarm tone that sounds when there
is a fault cannot be deactivated.
 Open the door.
 Switch the dishwasher off with the
 button, if it is switched on.
 Press the  button in and, while
holding it in, switch the dishwasher
on using the  button.
Keep the  button pressed in for at
least 4 seconds until the  indicator
light comes on.
If this does not happen, start the
procedure from the beginning again.
Programme options
 Press the  programme selection
button 4 times.
The top left programme indicator light
will flash rapidly 4 times at intervals.
The flashing sequence in the time
display indicates whether the signal
tones at the end of the programme are
activated or deactivated:
-  : Signal tones are activated.
-  : Signal tones are deactivated.
 Press the  button to change the
setting.
The setting is now stored in memory.
 Switch the dishwasher off with the
 button.
57