Advertisement
Technical data
Nominal voltage
Frequency
Nominal power
Water inflow temperature, max
Rated flow rate
Max flow rate
Pressure of the water supply, max
Rated Pressure
Allowable pressure
Sound pressure level
Sound power level
Guarantee sound power level
Vibration
Protection class
Degree of protection
Weight
Automatic engine shutdown
This high-pressure washer is equipped with an automatic engine shutdown. If, during operation, the trigger
(16) of the spray gun is activated, the engine automatically shuts down. By reactivating the trigger (16), the
engine restarts. During short work breaks, the spray gun trigger (16) (11) must be locked by the locking
system (15) to avoid an involuntary engine start-up. In case of longer interruptions, the operating switch (4)
must also be put on "OFF.
Use of detergents
This pressure washer is suitable for the use of universal cleaning agents for cars, for boats, for the house
and the garden, recommended by the manufacturer and approved for use with high pressure cleaners.
The use of other cleaning products or chemicals may impair the safety and functionality of the unit.
When using cleaning agents, the dosing and application instructions of the cleaning product
manufacturer must be observed.
Do not use aggressive cleaning agents.
Get advice on suitable cleaning products in specialized shops.
Before starting
It is recommended that a specialist install a current protection switch at the electrical connection of
the appliance; this will interrupt the supply, when the fault current exceeds 30mA for 30 ms.
Install the storage bracket on the right side of the machine. It will be used to install the gun later.
Press the end of the high-pressure hose (7) into the high-pressure outlet (5) and tighten it. Push the
other end of the high pressure hose into the gun. To remove the high pressure hose from the gun,
press the release button (17) and remove the hose.
Screw the connection (9) to the water inlet (8). Push the water hose (or screw it, depending on the
model) onto the fitting. Make sure that the fitting is in the correct position. The recommended
minimum length for the water supply hose is 10 meters (but not more than 25 meters) with a diameter
of 12.5 mm to prevent back pressure and potential damage to your appliance. Make sure it can
withstand water and a maximum pressure of 0,3 MPa (3 bars). If you want to connect your device to
other water sources, make sure that the maximum water inlet pressure is 0,3 MPa (3 bars)
Insert the nozzle into the gun. To remove the nozzle, pull the lock cover (18) back towards the gun and
230-240 V~
50 Hz
1400 W
60° C
5.0 l/min
6,6 l/min
0,3 MPa (3 bars)
7.0 MPa (70 bars)
10.5 MPa (105 bars)
87 dB(A) K = 3 dB
89,7 dB(A)
93 dB(A)
2,6 m/s² K = 1,5 m/s²
II /
IPX5
5 kg
Advertisement
