Advertisement
remove the nozzle.
Plug the power plug into a properly grounded outlet.
Turn the water supply on. If you use the pressure washer and the water supply is closed, it will cause
damage to the pump.
Getting started
Turn the service switch (4) to the "ON" position
Point the spray gun (11) down.
Unlock the locking system (15) of the spray gun (11) and fully depress the trigger (16).
Switch off
Release the trigger (16) and lock it with the locking system (15).
In case of longer interruptions, the pressure washer must be switched off with the operating switch (4).
("OFF").
Detergent bottle
The integrated detergent tank (10) allows the automatic addition of detergent to the wash water when
needed.
Remove the bottle cap counterclockwise to open the bottle (10).
Fill the bottle with detergent solution without exceeding the maximum level (see graduation on the
bottle). Close the bottle with its cap by turning it clockwise.
If installed, remove
into the gun body(11)
When preparing the detergent solution, follow the instructions or recommendations of the
manufacturer of the product used.
Cleaning operation
If necessary, start by cleaning the object in high pressure operating mode to remove most of the dirt.
Spray the detergent on the surface to be cleaned and let it act for a few moments (do not let it dry!).
Rinse at high pressure to remove the dirt that has been dissolved.
Jet nozzle
By turning the tip for the nozzle (19), you can choose between the linear jet (20) and the round jet (21) for
the projection nozzle.
Finish cleaning
Switch off the pressure washer with the operating switch (4) press "0FF" and unplug the plug.
Turn off the water supply and remove the device from the water flow.
Operate the spray gun (11) until the device is out of pressure.
Lock the trigger (16) of the spray gun with the locking system (15).
Disconnect the high pressure hose from the gun by pressing the lock button (17) and pulling the gun
hose down.
Keep the device in a safe, cool place out of the reach of children.
Before a long period without use and storage for the winter, operate the device for approx. 5 seconds
without water flow and without connecting the high pressure hose. The pump is thus emptied of the
maximum residual water and the risk of damage due to the possible presence of frozen water inside
the device is almost non-existent.
lance(12)
from gun body(11). Install the detergent bottle by pushing and
twisting it
Advertisement
