Installing The Intrusion Switch; Hard Drive And Optical Drive Module; Removing The Hard Drive And Optical Drive Module - Dell OptiPlex 3050 Small Form Factor Owner's Manual

Installing the intrusion switch

1. Insert the intrusion switch into the slot on the chassis.
2. Connect the intrusion switch cable to the system board.
3. Install the:
a. cover
4. Follow the procedure in

Hard drive and optical drive module

Removing the hard drive and optical drive module

1. Follow the procedure in
2. Remove the cover.
3. Remove the bezel.
4. To release the hard drive and optical drive module:
a. Disconnect the data and power cables from the connectors on the hard drive assembly [1] [2].
b. Unroute the cables through the clip [3].
c. Slide the release tab to unlock the hard drive and optical module [4].
16 Removing and installing components
After working inside your
Before working inside your
computer.
computer.