Related Manuals for Zephyr Tempest AK0714
Summary of Contents for Zephyr Tempest AK0714
- Page 1 www.zephyronline.com Tempest I , II Stainless Steel Backsplash AK0710 - 30” AK0716 - 36” AK0712 - 42” AK0718 - 48” AK0714 - 54” SEP16.0301...
- Page 2 LIST OF MATERIALS —————————–- 2 SPECIFICATION ———————————— 3 INSTALLATION ————————————- 4,5 CLEANING AND CONTACT INFORMATION ———————— 6...
- Page 3 1 - Upper Section 1 - Lower Section 2 - Wire Racks 1 - Hardware Packet 2 - Retaining Clips 4 - Hinge Clips 6 - 7/16” Carriage Head Bolts 8 - 5/8” Philips Head Wood Screw 6 - Carriage Head Bolt Nuts Note: If any parts are missing, please call 1-888-880-8368 for replacements.
- Page 4 30”,36”,42”,48”,54”...
- Page 5 30”,36”,42”,48”,54” 1. Mark a level line on the wall at 16” below bottom of hood. 2. Position the lower section of backsplash (flat part with flange on top) on the wall. Center it side to side and mark the top and bottom holes. Remove the lower section from the wall.
- Page 6 30”,36”,42”,48”,54” 1. For the warming plate option; snap the wire shelves into hinge clips on the backsplash as shown in the left side shelf diagram. 2. For the spice rack option; attach shelf to hinge clips, as show in the right side shelf diagram, then rotate shelf upwards and secure with retaining clip.
- Page 7 DO NOT place in a dishwasher as this may discolor the wire racks. You may also polish the stainless steel by using stainless steel polish. Make sure when polishing to go along with the grain of the backsplash. Zephyr Ventilation 2277 Harbor Bay Parkway Alameda, CA 94502...