Table of Contents
Advertisement
5. Install the protective cable boot. You may choose to skip this step if you are using the optional
junction box.
a. Remove the protective cable boot that is preinstalled over the Ethernet port, then thread one
end of the Ethernet cable through it.
Ensure the orientation of the cable and boot matches the one shown in the image.
b. Crimp the Ethernet cable.
c. After you connect the cable to the camera, slide the boot over the Ethernet port.
6. Connect the cable to the camera's Ethernet port.
7. Tuck the extra lengths of cables into the cable entry hole.
Mounting the Bullet Camera
8
Advertisement
Table of Contents
