Table of Contents
Advertisement
The required filters are:
– Nanofilter
Called Water Filter, this is an accessory on request.
– Osmotizer
Make sure the water coming out the filter is inside the
optimum area (Normal).
These filters also have the function of reducing the water
hardness to optimum values (below 5 f°), and therefore
also act as a water softener.
NOTE!
Periodical checking according to the filter manufac-
turer's instructions is important to maintain its
efficiency and avoid the risk of corrosion in the
appliance.
If water having characteristics outside those speci-
fied is used to create humidity inside the oven,
there will be the risk corrosion of the compartment
and that present inside it.
Carry out regular maintenance of the water soften-
ers and filters to ensure their optimum efficiency.
To avoid damage to the appliance, after every
periodical regeneration do a filter cleaning cycle
without introducing water in the oven.
The manufacturer declines any liability in case of
incorrect maintenance.
IMPORTANT
The use of dosing systems designed to prevent the
build-up of lime-scale in pipes (i. e. polyphosphate
dosing systems) is prohibited since such systems
may impair the performance of the appliance.
E.6
Electrical connection
E.6.1
Electrical connection
IMPORTANT
The connection to the electrical power supply must
be in compliance with the current national and local
regulations.
Before connecting, make sure the voltage and frequency
match that given on the dataplate.
• Connect the appliance to the power supply in a permanent
way with an H05 RN-F type cable.
• Install the power cable in a metal or rigid plastic pipe without
any sharp parts.
If the appliance is connected using an existing cable, do not
insert the installation tube in the appliance.
Also make sure the tube has no sharp edges.
• An isolating switch of suitable current rating with a contact
breaking distance of at least 3 mm, and a 16 A delayed-
action T type fuse must be fitted upstream of the appliance.
The isolating switch must be installed near the appliance in
the permanent electrical system of the premises.
• Install a device (interlocked plug, lockable switch or similar
devices) lockable in the open position during maintenance
ahead of the appliance.
• Connect the appliance to an efficient earthing system.
The earthing conductor must therefore be connected to the
terminal marked by the symbol
terminal board.
• The appliance must also be connected to an equipotential
bonding system.
• Include also the appliance into an equipotential system.
This connection is made with the setscrew marked
located externally near the power cable entry.
The equipotential wire must have a section of at least 10
mm
2
.
E.6.1.1 Power cable installation
To connect the power cable to the appliance, proceed as
follows:
1. Undo the two screws "V" fixing the terminal board panel
"P" under neath the appliance on the front left side;
2. Feed the power supply cable through cable clamp inlet
"B";
3. Connect the cable to terminal board "A" as shown in the
figure below;
on the connection
,
23
Advertisement
Table of Contents
