Table of Contents
Advertisement
• Remove the cardboard cover and the corners from the
appliance.
All models
• Lift the appliance with a lift truck, remove the pallet and
position the appliance in the place of use;
6 – 10GN models
20GN models
20 GN
IMPORTANT
Make sure not to damage the drain when removing
the appliance from the pallet.
• Remove the protective film from the panels, taking care not
to scratch the surface if scissors or blades are used;
E.4.2
Disposal of packing
The packing must be disposed of in compliance with the
current regulations in the country where the appliance is used.
All the packing materials are environmentally friendly.
They can be safely kept, recycled, or burned in an appropriate
waste incineration plant. Recyclable plastic parts are marked
as follows:
Polyethylene
• Outer wrapping
• Instructions bag
Polypropylene
• Straps
Polystyrene foam
• Corner protectors
The parts in wood and cardboard can be disposed of,
respecting the current regulations in the country where the
appliance is used.
E.4.3
Special precautions for positioning
For the overall space required and connection dimensions,
refer to the installation diagrams;
NOTE!
The appliance is not suitable for built-in installation.
When positioning the appliance keep in mind the following
minimum distances:
Minimum distances for positioning
normal working
right / left / rear distance 50 mm
work close to
left side distance 100 mm to 500 mm
heat source
service
left side distance 500 mm
conditions
• Position the appliance on a flat surface.
If necessary, adjust the height of the worktop by means of
the adjustable feet (if available).
21
Advertisement
Table of Contents
