Table of Contents
Advertisement
d. Sharpening of the chain
For best performance, we strongly recommend that you periodically sharpen the chain.
The chain can either be sharpened by a professional or by yourself by providing you
with a sharpening guide (make sure you know how to use it).
The chain must be sharpened when:
Wood chips have become powder
-
To make a normal cut, force on the tool
-
The cut is not straight
-
Vibration increases
-
Fuel consumption has increased
-
e. Checking the lubrication of the chain
Before checking the oil, make sure that the bar and the chain are in place.
-
Once the engine is started, turns it at medium speed and checks that the chain
-
oil is sprayed and traces off the ground.
The oil flow of the chain is adjustable to obtain the proper flow. Insert a
-
screwdriver on the clutch side.
Turn the adjuster to obtain the correct flow rate for the job.
-
The chainsaw must essentially consume the contents of the oil tank between
-
each full of fuel. Do not forget to fill the oil tank when filling the machine with fuel.
4. Cutting work
The tool should only be used to cut trees. Do not use it for other applications.
Do not attempt to remove the chainsaw when it is stuck during operation. Stop the machine
and remove the wedge blade with a wedge.
Stick your feet well, keep a good balance and do not climb on the tree trunk.
Try not to work on a slope. However, if you have to work on a slope, always stand higher
than the tree trunk.
Before bending a branch or trunk in bending, observe the direction of bending and finish
the cut opposite the bending side to prevent the chain guide from getting stuck in the cut.
a. Felling of trees
Examine the work area and estimate where the tree will fall. Start the machine as described
above.
Start
When the tree falls, shout or make a beep to alert people in the vicinity. When the shaft
falls, you must move away from the cutting area.
by
making
a
notch
15
in
the
direction
of
fall
chosen.
Advertisement
Table of Contents
