Table of Contents
Advertisement
Use your left hand to pull on the starter rope.
In both cases, the saw must remain away from the operator's body.
2. Stopping the engine
Allow the chainsaw to run for a few minutes. Then turn the switch to the OFF position.
3. Main settings
a. Adjusting the carburetor
The carburetor is preset at the factory. To avoid malfunction, it is recommended not to
adjust the adjustment screws. If these screws require readjustment, have the machine
serviced by your service center.
Stop the tool and tighten the needle L until it stops. Do not force it. Then set it to its
initial number of turns as shown below. The number of turns for the needle is also
shown below:
13
Advertisement
Table of Contents
