Advertisement
Owners Guide
Reservation Mode - Manual Transmission Models Only
TO INSURE SAFE STARTING OF MANUAL TRANSMISSION VEHICLES
1. With the vehicle running, apply the park brake then press and release the brake pedal.
2. The park lights will flash and the horn will honk (optional) to confirm that reservation mode has been activated.
3. Remove the key from the ignition, and exit the vehicle. (The vehicle will remain running until the door is closed)
4. The vehicle will shut off. (If the vehicle has a delay dome-light, the vehicle may run until the dome-light turns off)
THE VEHICLE IS NOW IN RESERVATION MODE AND MAY BE REMOTE STARTED.
Note: To enter the vehicle without canceling the Reservation Mode, the remote starter must be On while the door is opened
then closed. For safety reasons, Reservation Mode must be reset each time a door is opened while the engine is off.
Remote Start
1. Press and release the
2. The Park lights will flash and the horn(optional) will honk one time.
3. When the vehicle has started, the park lights four times then remain "On" while the vehicle is running.
4. The vehicle will continue to run for the programmed runtime. (normally 15 minutes).
Extended Run Time
1. Press and release the
2. The system will respond with one park light flash and one horn honk (optional) to
confirm Extended Runtime. The system will reset the run time, (normally 15 minutes).
Remote Stop
1. Press and hold the
2. The park lights will flash two times and the horn(optional) will honk two times.
Note: Pressing the brake pedal or opening hood will also deactivate the remote starter.
Idle Mode
1. While the vehicle is running with key, press the
2. The park lights will turn on and the horn(optional) will honk once.
3. Turn the ignition key "Off" and the vehicle will continue to run.
4. Exit the vehicle and leave it running without the keys. Always lock the doors if the vehicle is left running.
Timer/ Optional Temperature Start Mode.
1.Press and release the # button, then press and hold the
confirm entering Low Temperature Mode.
2. While the park lights are "on" the start cycle can be selected.
1 hour cycle or 0c
2 hour cycle or -5c
3 hour cycle or -15c
4 hour cycle or -25c
3. The system will start the vehicle at the selected start cycle. The vehicle will run for it's runtime then shut off. The
system will repeat this for a maximum 24 hour period.
4. The temperature sensor must be installed for temperature activation. The system will only
trigger 1 time each 2 hours. If the sensor is not installed the unit will activate the timer mode.
To Cancel Timer/ Temperature Start Mode.
1. Press and release the # button, then press and hold the
2. The System will respond with two flashes and two horn honks (optional).
Note: Remote starting or starting with the key will also cancel Timer/ Temp Mode.
Diagnostics
If the system fails to start, a diagnostic will be displayed by the vehicles park lights. Count the number of flashes then compare to the
chart below. The system will not function until the problem causing the code is corrected.
PARK LIGHTS
3 Flashes
3 Slow Flashes
4 Flashes
4 Slow Flashes
5 Flashes
6 Flashes
7 Flashes
8 Flashes
REMOTE STARTER FEATURES
button.
button while the vehicle is remote started.
button for three seconds. The remote starter will shut down.
Press the LOCK button
Press the UNLOCK button
Press the
button
#
Press the
button
STATUS LED
Series of 3 Flashes
LED's On Solid
Series of 4 Flashes
Series of 4 Flashes
Series of 5 Flashes
Series of 6 Flashes
Series of 7 Flashes
Series of 8 Flashes
button.
button for six seconds. The parking lights turn "On" to
1 park light flash
2 park light flashes
3 park light flashes
4 park light flashes
button for four seconds.
DIAGNOSTIC CODE
Door Opened "M" Models
System Is In Service Mode
Hood or Brake before start
Not in Reservation Mode "M" units
Brake Pedal Shutdown
Hood Pin Grounded
Tach Lock-Out
3 Start Attempts with no start
3
Advertisement
