Wickes BMS2102 Manual page 15

7. LASER GUIDE(SEE FIG. K1, K2)
Press the laser on/off switch to turn the laser on. The
laser device can provide a beam in the same plane as
the blade, which projects onto the workpiece to generate
a line. The saw blade can be directed to follow the line
in order to align the cut. Either straight cutting or bevel
cutting, it will aid the precision of your cut.
Press the laser on/off switch again to turn the laser off.
NOTE: Clean the laser generator periodically.
WARNING: Never stare directly into the laser
beam and never point the beam at anybody.
The laser beam energy is extremely harmful to
human eyes.
OPERATION
1. STARTING THE SAW (SEE FIG. L1, L2)
1) Push the lower blade lock lever outwards a little and
hold it, so that the lock lever is far away from the
upper fixed guard, and the lower rotating guard can
rotate upwards. Then press down the saw head by
holding the operating handle.
2) Squeeze the on/off switch to turn on the saw and
allow the blade to reach full operational speed.
4) Gently but firmly lower the saw head and allow the
blade to cut through the workpiece.
5) When the cut has been completed, hold the saw head
in the down position and release the on/off switch.
6) Let the blade stop completely before allowing the
saw head to rise to its upper position.
7) Remove your hand from the operating handle only
when the saw head is raised, the blade is stationary
and the lower blade guard is covering the blade.
Fig. K1
Fig. K2
Fig. L1
Fig. L2
15
2
1