Wickes BMS2102 Manual page 11

Fig. B3
3. WORK CLAMP (SEE FIG. C)
When cutting workpieces, they should always be
clamped with a work clamp. The work clamp can be
fitted on either side of the saw and is fully adjustable to
suit the size of the workpiece.
To install the work clamp, just insert it into the hole
located at rear of the fence on either side of the base.
Work clamp lock knob is used to secure the work clamp
on the base. Adjustment knob (a) is used to adjust the
height of the rail (b).
Adjustment knob (c) is used to lock the workpieces.
NOTE:
•
Do not operate the saw without clamping the
workpiece.
•
Make sure that the work clamp securing screws are
tightened.
Fig. B2
Fig. B1
Fig. B4
c
11
Fig. C
a
b