Wickes BMS2102 Manual page 13

2. MITRE TABLE LOCK (SEE FIG. F1, F2)
The mitre table lock latch is used to lock the table at the
desired mitre angle.
NOTE: Assemble the mitre table lock handle before
adjusting mitre angle. Insert the handle into the lock arm
and tighten it.
The mitre saw cuts from 0° to 45° both left and right. To
adjust the mitre angle, hold the mitre table lock handle
and depress the mitre table lock latch, then you can
move the lock handle to the left or right in order to adjust
the rotating mitre table to a desired angle. Release the
mitre table lock latch to lock the rotating mitre table in
the required position.
The rotating mitre table features positive click stops at
0°, 15°, 22.5°, 30° and 45° for quick setting of common
mitre angles.
3. BEVEL LOCK (SEE FIG. G1-G4)
The bevel lock is used to set the blade at the desired bevel angle. The mitre saw bevel cuts from 0° to 45° to the left (the
saw blade is facing to the operator). To adjust the bevel angle, follow the steps below:
1) Loosen the locking bolt (d) using the M5 hex key provided located on the extended fence for bevel cutting. Pull the
extended fence outwards to its farthest position. (See Fig. G1) Tighten the locking bolt again to lock the fence.
2) Loosen the bevel lock lever by turning it anti-clockwise and move the saw head to the left (the saw blade is facing to
the operator) to a desired bevel angle (between 0° and 45°). (See Fig. G2)
3) Turn the bevel lock lever clockwise and the lock lever touches the slide rod before tightened. (See Fig. G3) At this
time you should first depress the end of the lock lever bar, and pull the lock lever outwards a little, then turn it anti-
clockwise back about half round, at last turn it clockwise again. Repeat the steps until the lever is fully tightened.
(See Fig. G4) Note that assemble the work clamp on the right side before adjusting into bevel cut mode.
Fig. G1-1
d
1
30
Fig. G1-2
2
Fig. F1
Fig. F2
Fig. G2-1
1
13
Fig. G2-2
2