Table of Contents
Advertisement
WIND DASHES: WHY ARE THERE DASHES FOR WIND READINGS?
First, press the EXTRA SENSOR button on your station to view the ID number for the Station.
Compare it to the first six characters on the barcode on the back of the station.
• If they match-Continue with the troubleshooting below.
• If they do not match contact support.
In some cases, under extended periods of cold and/or dark conditions, the sensor can get stuck
in a low-power mode of sorts. To kick it back on, simply remove and reinsert the batteries.
However, if this still does not resolve the problem, please try the following steps:
Be sure to mount the Breeze Pro Sensor level, with the solar panel facing south, and in an
1.
open area to allow for the most sunlight possible.
It can help to search for the sensor again by pressing and releasing the WIND button on the
2.
display until the orange wind section lights up (usually 3 presses). Then press and hold down
the MINUS button until the station beeps and the Reception Icon starts to animate.
If step 5 did not work, please try a full factory restart, by pressing and holding the RAIN and
3.
ALERTS buttons down together until everything resets. Then remove the power cord from
the display and press any button at least 20 times. Wait a few moments before powering the
display back up.
Dashes indicate the connection is lost between your station and the wind sensor.
•
My first thought is always to check that my
now is not, low batteries are the most common connection problem.
•
Next, check your
distance, resistance, and
at the same location, this is not the issue. However, sometimes there is new growth on trees
or bushes that cause another barrier. Radio Frequency (RF) signal does not travel well
through foliage due to the moisture content.
•
Occasionally adding a new wireless electronic device to the home will cross the signal path
for the sensor. If this occurs, try moving your station a few feet or turning the station 90
degrees for a better angle to receive the sensor signal.
•
Press the EXTRA SENSOR button until you see your sensor ID. Hold the PLUS (+) button for 3
seconds and your station will search for your sensor.
•
If you regain connection while the sensor is mounted, great. If you do not regain connection,
bring the sensor within 10 feet of the station and search again.
batteries
are good. If it has been working and
interference. If everything was working previously
22 |
P a g e
Advertisement
Table of Contents
