Rimage Professional 5100N Setup And Installation Manual page 2

4
Connect the printer cables.
a. Connect the power cord from
the Professional to the printer.
5
Connect the Professional cables.
a. Be sure that the main power switch at the back of the 5000N is in the
Off position.
b. Connect the power cord from the Professional to a power outlet.
Important! Do not power on the Professional until you are instructed
to do so.
Mouse*
Keyboard*
Main Power Switch
c. Connect the network cable to the embedded control center.
d. Connect a monitor, mouse, and keyboard (optional).
*A monitor, keyboard, and mouse are required only if the system is not
connected to a network.
Copyright © 2008 Rimage Corporation
6
Power on the Professional.
a. Set the main power switch at the back of the Professional
to the On position.
b. Connect the printer
cable to the printer.
c. Connect the USB b. Press the embedded control center power button on the front of the
Professional to power on the system.
cable to the printer.
c. Allow the system to complete initialization.
7
Install the printer
Follow the prompts in the New Hardware Wizard to install the printer.
Network Cable
Monitor*
Power Cord 8
Align the printer.
For instructions on how to align your printer, refer to the Rimage 5100N and
5300N User Guide included with your product.
Main Power Switch
Embedded Control Center
Power Button
Note: Initialization may take up to 5 minutes. When the Professional
completes the initialization, the operator panel displays [RIMAGE 5000N
READY].
9
Confi gure the Professional and add clients.
Important! Rimage recommends that your Network Administrator use these
instructions as a guide to complete the confi guration and software installation.
• If the system is connected to a network, access is made through Microsoft
Remote Desktop Connection running on a separate PC. See the Advanced
Setup Guide (110721) for more information on accessing Remote Desktop
Connection.
Note: If there is more than one Professional on the network, change
the computer name. See the Advanced Setup Guide (110721) for more
information.
• If you connected a monitor, keyboard, and mouse, log into the Rimage
Professional with the following username and password:
Username: Administrator
Password: password
10
Activate your Rimage Software.
You have 30 days to activate your Rimage software.
Until your software is activated, you will be prompted to activate your
software each time you use the Rimage software.
When the activation dialog displays, select an option and follow the on-screen
prompts to activate your software.
11
Test and verify.
Run a 3-disc test job to verify that the system is operating correctly.
12
Learn more.
For information about how to operate and maintain the Professional, refer to
the Rimage 5100N and 5300N User Guide included with your product.
For additional support and product information, go to www.rimage.com/
support.html.
2000448_D