Installation Environment Requirements; Mechanical Safety - Redx RX- 0050 Manual

RX-0050
Lithium iron phosphate battery system User Manual

1.4 Installation Environment Requirements

If any liquid is detected inside the equipment, immediately disconnect the power supply and
contact the vendor.
Do not expose the equipment to flammable or explosive gas or smoke. Do not perform any
operation on the equipment in such environments.
The environmental temperature must be between 0 °C and +50 °C, and the relative humidity.
Between 0% and 90% (without condensation).
Install on a sturdy supported surface. Indoor installation only.

1.5 Mechanical Safety

Using Ladders
Use wooden or fiberglass ladders when you need to perform live working at heights.
When a step ladder is used, ensure that the pull ropes are secured and the ladder is held firm.
Before using a ladder, check that it is intact and confirm its load bearing capacity. Do not
overload it.
Ensure that the ladder is securely positioned. The recommended angle for a ladder against
the floor is 75 degrees, as shown in the following figure. An angle rule can be used to measure
the angle. Ensure that the wider end of the ladder is at the bottom, or protective measures have
been taken at the bottom to prevent the ladder from sliding.
Document Version: V1.1
Issued Date: 2023-03-29
Figure 1-1 wearing an ESD wrist strap
6