Advertisement
4. Configuring your device (Menu 2)
2
>5s
1
❶ Turn the dial to
, then press the
i button for 5 seconds (❷).
Menu 2-01 Locking or unlocking the settings
This menu enables you to authorise or lock changes to the settings such as programming or setpoint temperatures.
Locking only applies to settings entered via the Tybox.
Default setting: Changes allowed
No changes to the programme.
Adjusting setpoint temperature settings.
Menu 2-02 Correcting the measured temperature
This menu is used to correct any difference you have notcied between the displayed temperature and the
measured temperature.
Example: If the temperature displayed by the device is 19°C and the measured temperature is 20°C, change to +1°C
then confirm using OK.
Default setting: 0°C
Adjusts from -5°C to 5°C,
in increments of 0.1°C.
Menu 2-04 Temperature displayed in AUTO mode (setpoint or room)
Default setting: setpoint temperature displayed.
setpoint temperature
Menu 2-05 12h/24h time format
Default setting: 24h
Menu 2-06 Automatic summer/winter changeover
Default setting: Automatic changeover
No automatic changeover
Automatic changeover
3
❸ Press the 2 button.
To change the various settings,
press the + or - buttons (❹), then
press OK to confirm the change and
go to the next setting (❺).
Changes allowed
Displays
Displays
room temperature
24 h
12 h
1
4
0
5
Adjustment in manual and Comfort mode
limited to between 5°C and 22°C.
Economy setting limited to between 5°C
and 19°C.
Frost protection setting limited to between
5 and 11°C.
In order to change this setting, the unit
must have been running for at least 2 hours
beforehand.
In normal use, press the
to check one or other of the temperatures.
1
0
6
❻ To exit the mode, turn the dial.
i
button
EXIT
6
Advertisement
