Advertisement
3. Configuring your device (Menu 1)
2
>5s
1
❶ Turn the dial to
, then press the
i button for 5 seconds (❷).
Menu 1-02 Programme duration
You can set programming by the hour, half hour, or quarter of an hour.
Default setting: 1 hour.
Menu 1-03 Pre-heat activation/deactivation
Pre-heat means you can enjoy the Comfort temperature you want at the scheduled hour (see § "Pre-heat
function").
Default setting: Pre-heat off
Menu 1-08 Controlling the Comfort temperature
For hot water heaters with thermostatic valves, the Comfort temperature can be provided by adjusting the
thermostat on each radiator.
In AUTO mode, the device will show "Conf" during Comfort periods and will be set to constant heating. Only the
Economy and Frost Protection temperatures are controlled by the Tybox.
Default setting: Comfort temperature is controlled by the Tybox.
Comfort temperature controlled by Tybox
Comfort temperature controlled by each radiator
Menu 1-09 Anti-seize activation/deactivation
Anti-seize can be used outside heating periods to regularly start up the circulator/boiler/heatpump during off
periods (5 minutes/week).
Default setting: Anti-seize off
3
❸ Press the 1 button.
To change the various settings,
press the + or - buttons (❹), then
press OK to confirm the change and
go to the next setting (❺).
60 min.
30 min.
15 min.
Pre-heat off
Pre-heat on
Anti-seize off
Anti-seize on
2
4
0
5
Menu 1-03 does not appear if the Comfort
temperature is controlled by each radiator
(menu 1-08 = 1).
Menu 1-08 does not appear if pre-heat is
active (1-03 = 1).
Choice 1 turns off pre-heat (1-03 = 0). In this
case, menu 1-03 no longer comes up.
1
0
6
EXIT
❻ To exit the mode, turn the dial.
5
Advertisement
