Miele PW 5105 Vario Operating And Installation Instructions page 60

Installation
Electrical connection
,
This installation should be
performed by an experienced and
qualified technician, in accordance
with local codes and regulations.
This machine is supplied with a
connection cable without a plug for
connection to a suitable connection
socket or isolator switch.
,
Before installation, make sure
that the voltage and frequency listed
on the data plate correspond with
the site's electrical supply.
This machine must be connected to the
electricity supply in accordance with
local and national safety regulations.
Connection to the electricity supply
must only be carried out by a suitably
qualified and competent person.
If the appliance is hard wired, a
multiple-pole separator must be
installed. Separators with a contact gap
of more than 1/8" (3 mm) are valid as
separators. All components have to
bear CSA or UL approval.
The plug connection or the separator
must be accessible at all times.
You must be able to lock the separator
or monitor it at all times in case the
appliance has to be disconnected from
the power supply.
60
,
If the machine is disconnected
from the electricity supply ensure
adequate measures are taken to
ensure that the machine cannot be
reconnected to the electricity supply
until all work has been carried out.
Should the connection cable require
replacing or changes be necessary in
the electrical installation including
checking and/or replacing the fuse
please make sure this is done by an
approved electrician to ensure
compliance with all local and national
electrical safety requirements.
For extra safety, it is advisable to
protect the machine with a suitable
residual current device (RCD).
WARNING:
THIS APPLIANCE
MUST BE GROUNDED