Advertisement
Rectifying faults
Resetting JOBs (welding tasks) to the factory settings
7
Rectifying faults
All products are subject to rigorous production checks and final checks. If, despite this, something fails to
work at any time, please check the product using the following flowchart. If none of the fault rectification
procedures described leads to the correct functioning of the product, please inform your authorised dea-
ler.
7.1
Resetting JOBs (welding tasks) to the factory settings
All customised welding parameters that are stored will be replaced by the factory settings.
Instructions on how to reset welding tasks (JOBs) to the factory setting can be found in the JOB mana-
ger > see 5.6.2 chapter chapter.
7.2
Display machine control software version
Identifying the machine software is key to quick troubleshooting by the authorised service technician. The
version number is shown on the initial screen of the machine control for about 5 seconds (switch the ma-
chine off and on again) > see 4.2.3 chapter.
74
099-00L100-EW501
4.7.2019
Advertisement
Need help?
Do you have a question about the L1.01-Expert 2.0 and is the answer not in the manual?
Questions and answers