Installing Printer Hard Disk Type4510 - Ricoh Aficio AP4510 Setup Manual

Installing Options
M M M M
Close the connector cover.
2
Note
❒ Print a configuration page to
confirm that the Paper Bank is
properly installed. See "Printing
a Configuration Page" in the
Printer Reference on the CD-
ROM labeled "Operating In-
structions".
Installing Printer Hard Disk
Type4510
R CAUTION:
• Do not touch the inside of the
printer board compartment. It
may cause a machine malfunc-
tion or a burn.
Important
❒ The Printer Hard Disk can be dam-
aged by a small amount of static
electricity. You should touch some
metal to discharge static electricity.
❒ When the bidirectional transmis-
sion is not in operation, you must
set up the installed Printer Hard
Disk using the printer driver in or-
der to use it. See p.37 "Installing
the Printer Driver and Software"
for setting up options. See p.48
"The conditions of the bidirection-
al transmissions" for information
about bidirectional transmission.
18
❒ When the Printer Hard Disk is be-
ing accessed, the Data In indicator
blinks. Do not turn off the printer
power when the Data In indicator
is blinking as it may destroy the
hard disk.
❒ When a print job is being spooled,
the printer sends data to the hard
disk, and the Data In indicator
blinks. Do not turn off the printer
or computer while a print job is be-
ing spooled, as it may destroy the
hard disk or the spooled job will
remain in the hard disk and be
printed repeatedly until erased.
A A A A
Check the contents of the box for
the following items:
• Printer Hard Disk
• Installation Guide
• Power Cord
• Connector
B B B B
Turn off the printer.
C C C C
Pull out the first paper tray (Tray
1) and take the screwdriver (A A A A )
from the tray. Each screw to be re-
moved requires this screwdriver.
ZFCP720E