Nibe F1345 Service Manual page 61

Circuit board and electronics
NOTE
An ESD bracelet must be worn when replacing the card.
Base card (AA2 och AA26)
1 Remove top panel on the
heat pump (6x screws). See
instruction page 46.
2 Disconnect the cables and
connectors to the card.
3 Remove the screws that
secure the card.
4 Remove the card from the
plastic clips (2x) by holding
in the clip hooks and pulling
the card upwards.
5 Replace the card.
F1345
AA26
Screw
AA2
Plastic clip
Chapter 7 | Component replacement 61