Advertisement
en Drying
21.2 Setting the descaling function
Requirement: → "Preparing descaling", Page 29
1.
Press
.
2.
In the operating mode menu, select "Descaling".
a The duration appears in the display. The duration
cannot be changed.
3.
Press
to start.
a The descaling programme starts and the duration
counts down.
a Once the first part of the descaling programme has
finished, an audible signal sounds. The appliance
prompts you to rinse twice.
4.
To rinse the appliance, for each rinse cycle:
22 Drying
To prevent residual moisture, dry the cooking compart-
ment following operation.
ATTENTION!
If there is water on the cooking compartment floor
when operating the appliance at temperatures above
120 °C, this will damage the enamel.
▶
Do not use the appliance if there is water on the
cooking compartment floor.
▶
Wipe away any water on the cooking compartment
floor before operation.
22.1 Drying the cooking compartment
You can dry the cooking compartment by hand or use
the drying function.
1.
Allow the appliance to cool down.
2.
Remove dirt from the cooking compartment.
3.
Wipe away the water in the cooking compartment.
4.
Dry the cooking compartment.
Leave the appliance door open for one hour to
‒
dry the cooking compartment by hand.
23 Appliance door
To clean the appliance door thoroughly, you can disas-
semble the appliance door.
23.1 Detaching the appliance door
WARNING ‒ Risk of injury!
Components inside the appliance door may have sharp
edges.
▶
Wear protective gloves.
The hinges on the appliance door move when the door
is opened and closed, which could trap your fingers.
▶
Keep your hands away from the hinges.
1.
Open the appliance door fully.
30
Open the control panel and remove the water
‒
tank.
Thoroughly rinse the water tank and fill it with
‒
fresh water.
Slide in the water tank and close the control
‒
panel.
Use
to start rinsing.
‒
a A signal sounds when each rinse cycle has ended.
5.
Once the second rinsing cycle is complete:
Empty and dry the water tank.
‒
→ "Emptying the water tank", Page 18
Press
to switch the appliance off
‒
a Descaling is complete and the appliance is ready
for use.
In order to use the drying function, set the drying
‒
function.
→ "Setting the drying process", Page 30
Setting the drying process
1.
Allow the appliance to cool down.
2.
Remove coarse dirt from the cooking compartment
and wipe away moisture from the cooking compart-
ment floor.
3.
Press
.
4.
In the operating mode menu, press the drying oper-
ating mode.
The duration is set to 10:00 min. and cannot be
changed.
5.
Press
to start the drying function.
a The appliance starts to dry and the duration counts
down.
6.
Once the duration has elapsed:
A message appears in the display.
‒
Press
to silence the audible signal before
‒
it is due to end.
Press
to switch the appliance off.
‒
Advertisement
