Placing A Single Original On The Exposure Glass; Placing Originals In The Adf - Ricoh Aficio 1515 Facsimile Reference Manual

Faxing
Make sure that all ink, correcting
fluid etc., has completely dried be-
fore placing your original. If it is
still wet, the exposure glass will be
marked and those marks will ap-
pear on the received image.
You can send the first pages from
the exposure glass then the re-
2
maining pages from the ADF. Af-
ter you have removed the last page
from the exposure glass, insert the
remaining pages in the ADF, and
then press the {Start} key.
Reference
For acceptable types of originals,
see p.107 "Acceptable Types of
Originals", Facsimile Reference <Ad-
vanced Features> .
Placing a Single Original on
the Exposure Glass
Place originals that cannot be placed
in the ADF (Auto Document Feeder),
such as a book, on the exposure glass
one page at a time.
A
Place the original face down and
align its upper left corner with the
reference mark at the upper left
corner of the exposure glass.
ABZ025S.eps
1.
Positioning mark
2.
Left Scale
14
B
Lower the exposure glass cover or
the ADF.
Note
When setting a bound original,
the received image may contain
some black areas. To reduce this
effect, hold down the original to
prevent the bound part from
rising.

Placing Originals in the ADF

Use the ADF to scan in a stack of orig-
inals in one operation.
Limitation
Place all the originals to be sent in
a single stack. You cannot place
originals in the ADF one page at a
time or in successive stacks.
Note
To send an original longer than the
following lengths, use Memory
Transmission. However, the maxi-
mum length of an original for
Memory Transmission is 1200 mm
(47").
• A4 size: 600 mm (23.6") for De-
tail, 300 mm (11.8") for Fine
If you frequently send long docu-
ments, set Long Document Trans-
m i s s i o n t o o n w i t h t h e U s e r
Parameters. If a jam occurs, the
document might be damaged be-
cause scanning will not stop. See
p.76 "User Parameters", Facsimile
Reference <Advanced Features>
(switch 14, bit 1).
If your original is bent or folded,
flatten it before you place it.
When sending thin originals, place
ABZ025S
them on the exposure glass.
If an original jammed, press the
{Clear/Stop} key, and then slowly
remove the original.