Loudspeaker Overview; Salon2 Driver Complement; Studio2 Driver Complement; Cabinet - REVELL Ultima Gem Owner's Manual

LOUDSPEAKER OVERVIEW

SALON2 DRIVER COMPLEMENT

The numbers in Figure 2 on the next page correspond with the
numbered items below.
1. (1) 1-inch (25mm) Beryllium tweeter
2. (1) 4-inch (102mm) midrange
3. (1) 6.5-inch (165mm) mid-woofer
4. (3) 8-inch (203mm) woofers

STUDIO2 DRIVER COMPLEMENT

The numbers in Figure 3 on the next page correspond with the
numbered items below.
1. (1) 1-inch (25mm) Beryllium tweeter
2. (1) 5.5-inch (140mm) midrange
3. (2) 8-inch (203mm) woofers

CABINET

The Revel Salon2/Studio2 Loudspeakers exemplify subtle
elegance with their smooth, rounded shapes, which easily blend
in with a wide variety of decors. Available in either a high-gloss
mahogany veneer or a high-gloss black finish, the Salon2/
Studio2 Series Loudspeakers will be a welcome compliment to
any home. The Salon2/Studio2 reduces cabinet-induced
colorations with 1-inch (25mm) thick walls and extensive
internal bracing. Adjustable combination spikes/glides can be
attached to the bottom of the cabinet stands for optimal stability,
accommodating installations on tile, hardwood, and carpeted
floors.
6
The cabinet's wood veneer finish does not require routine
maintenance. Cabinet surfaces that have been marked with
dust, fingerprints, or other dirt can be cleaned using a soft cloth
and high-quality wax.
• To clean the cabinet, apply furniture polish to a soft cloth
then use the cloth to lightly wipe the cabinet surface. Use
care to avoid coming into contact with the tweeter dome or
any of the other drivers.
• To clean the grille, gently vacuum using a soft-bristled
brush vacuum attachment.
Caution
Use caution not to touch or allow any object or liquid to come
in contact with the Beryllium tweeter dome. Variations in its
finish are normal. Any attempt to clean the tweeter dome will
result in damage which is not covered under the limited
warranty. To prevent cabinet damage, do not use a cloth made
with steel wool or metal polish to clean the cabinet. To prevent
possible transducer damage, do not apply furniture polish
directly to the cabinet or tranducers.

REAR DOOR PANEL

The Salon2/Studio2 comes with a pre-installed rear panel door.
To connect a speaker cable:
• Open the door by pressing the "finger berm" on the left side
of the door.
• Determine the rear panel configuration that is suitable for
your installation and attach the speaker cable. (Refer to the
"Making Connections" section for more information.)
• Align the cable so that it fits within the center bottom
channel of the door.
• Close the door by pressing on the "finger berm" on the left
side of the door. Ensure that the door closes completely, and
does not crimp or jam on any of the cables.
Ultima Salon2/Studio2
Owner's Manual