REVELL Performa F52 Owner's Manual page 16

Making Connections
• When making bi-amplified connections,
both power amplifiers must receive
identical input signals from the
associated preamplifier. A "Y" adaptor
is required if the associated preamplifier
does not offer two connectors per output
channel. Otherwise, each power
amplifier can be connected to a
separate connector for the same output
channel of the preamplifier.
SINGLE-WIRED CONNECTIONS
Single-wired connections are the most
common. These are made between one
pair of F52 input terminals and one power
amplifier output channel as shown in
Figure 7 (right).
To make single-wired connections:
1. Connect one pair of loudspeaker wires
to the desired F52 input terminals.
Then connect the same pair of
loudspeaker wires to the desired power
amplifier output channel. (The high-
frequency input terminals are
recommended.)
2. Repeat step 1 to connect the second F52
to a separate power amplifier output
channel.
REVEL Performa F52
16
OWNER'S MANUAL
(continued)
• If desired, contact an authorized Revel
dealer for information about the
suitability of power amplifier compo-
nents before connecting the F52 to the
associated power amplifier.
• Review the owner's manuals for
associated audio components to
determine their connection procedures.
Figure 7: Single-Wired Connections
Contour
Normal Boundary
Low Frequency
Compensation
Remove straps
for bi-wire
Low Frequency Input or bi-amp
F52
POWER
AMPLIFIER
OUTPUT
0
-.5 +.5
-1 +1
Tweeter Level
(dB)
High Frequency Input
Revel
Northridge, California
Assembled in U.S.A.
Serial No.