REVELL Performa F52 Owner's Manual page 14

Adjustable Spikes
(continued)
5. Rotate the spike clockwise into the
cabinet, round end first, as shown on
the right side of Figure 6 (below).
6. Reattach the locking ring, rotating it
clockwise to firmly secure the spike to
the cabinet.
7. Repeat steps 2 through 6 for the
remaining three spikes. In step 6, make
sure to thread each locking ring to
achieve a level balance.
8. When all four spikes have been
reversed, stand the F52 in the upright
position. If needed, repeat steps 1 and
6 to achieve a level balance.
Figure 6: Adjustable Spikes
Spike End
Round End
Protective Cap
REVEL Performa F52
14
OWNER'S MANUAL
F52
When shipped, the spikes
are attached as shown here
for loudspeaker placement on
tile or hardwood floors.
Spike End
Locking Ring
Round End
(Protective Cap
Attached)
9. Repeat these steps to adjust the spikes
on the other F52.
CAUTION
Floor-standing loudspeakers such as the
F52 have a high center of gravity, which
may cause them to fall if tipped or
improperly positioned.To avoid this,
anchor the loudspeaker to the floor
and/or wall using the same procedures
and hardware used to anchor bookcases,
wall units, and other furniture. Harman
Specialty Group assumes no responsibility
for proper selection and installation of
hardware or for any personal injuries or
product damages resulting from improper
installation or a fallen loudspeaker.
The spikes should be
attached as shown here
for loudspeaker placement on
carpeted floors.
Round End
(Protective Cap Removed)
Locking Ring
Spike End