Supermicro SuperServer SYS-621H-TN12R User Manual page 61

3. Determine whether your M.2 SSD is 80mm or 110mm. If the plastic clip is not in the
correct hole, move it.
a. To remove the plastic clip, twist it 90 degrees and pull up.
b. To insert the plastic clip, push it into the correct mounting hole and twist 90 degrees.
Figure 3-13. Installing a Plastic Locking Clip and M.2 SSD
4. Insert the M.2 SSD sideways into the connector on the motherboard so that it lays flat,
then secure it to the motherboard with the plastic clip.
5. Replace the cover and restore the power to the system.
Chapter 3: Maintenance and Component Installation
3
3 3
4
61