Supermicro SuperServer SYS-621H-TN12R User Manual page 57

Figure 3-9. Installing a 3.5" Drive into a Carrier
Installing a 2.5" Drive
1. Remove the dummy drive, which comes pre-installed in the drive carrier. Pull out the two
locking clasps on the left outside of the carrier and lift out the dummy drive.
2. Install the drive directly into the tray with four screws underneath.
3. Insert the drive carrier into its bay, keeping the release button on the right. When the
carrier reaches the rear of the bay, the release handle will retract.
4. Push the handle in until it clicks into its locked position
2.5" Drive
Figure 3-10. Installing a 2.5" Drive into a Carrier
Chapter 3: Maintenance and Component Installation
4
2
57
Insert this side second