Table of Contents
Advertisement
36
5.5 How do I choose a chart type?
You choose the type of chart you want to display using the charting toolbar.
There are four primary buttons on the toolbar for controlling the type of chart being
displayed. There is also a button to enable or disable radar overlay, and a button to
enable or disable chart quilting.
To select the chart type to be displayed:
Click the button for the type of chart you want to be displayed. The button will
highlight to indicate that chart type has been selected.
If there is no chart type enabled, or charts are unavailable at the level of zoom that has
been selected, only an aquamarine colored background will be visible. You can either
select a chart type from the toolbar, or adjust the zoom level, using the range buttons,
until the chart is visible.
5.6 How do I use chart layers?
If you have multiple chart buttons enabled at the same time, then your chart is layered.
This means that one type of cartography is superimposed on top of one or more other
types of cartography.
All charting layers, except C-Map, have a transparency control which allows you to
increase or decrease a layers transparency. Each page or pane will default to it's full
transparency level when it is first opened.
To adjust layer transparency:
1. Click the down arrow at the right of the chart type. The transparency slider is
displayed.
2. Move the cursor over the transparency slider.
i. To make the layer more opaque, place the cursor over the right of the
ii. To make the layer more transparent, place the cursor over the left of the trans-
Down
arrow
transparency slider and click. The value increases.
parency slider and right-click. The value decreases.
Transparency
slider
RayTech RNS V5.0 - User's Manual
D6984_1
Advertisement
Table of Contents
