Table of Contents
Advertisement
Chapter 2: Getting Started
Chapter 2: Getting Started
2.1 Introduction
This chapter describes getting started with RNS and covers the following:
• Installing RNS.
• Starting to use RNS.
• Setting up RNS.
• Installing charts.
For details on installing system hardware refer to - RayTech RNS - Getting Started.
2.2 How do I install RNS ?...
Your RNS software can be installed from either a CD-ROM or downloaded directly from
the Internet. This section describes both methods and how to open RNS after
installation.
from a CD
To install RNS using a CD-ROM:
1. Insert the RNS CD into the computer's CD-ROM drive. After a few moments the
Install Shield Wizard Welcome screen is displayed.
2. Click
If the Install Shield Wizard does not automatically run;
1. Select Start/Run from the computer taskbar and type e:\Raytech\setup.exe
(substitute the drive letter of your CD-ROM drive for 'e' if it is different). After a few
moments the Install Shield Wizard Welcome screen is displayed.
2. Click
from the internet
To install RNS from the internet:
1. Point your internet browser to http:///www.raymarine.com/RayTech Software.
2. Click
3. Follow the on-screen instructions.
RNS is a very large file (85MB). Dial-up connections are not recommended for this
Note:
operation.
Next,
and follow the on-screen instructions.
Next
, and follow the on-screen instructions.
Download RayTech
.
9
Advertisement
Table of Contents
