Fig. 2-14 Flush-Mount Installation - Raymarine L750 Operating Handbook

20
behind the area where the display unit will be mounted. It is a good
idea to drill a small pilot hole in the center of the mounting area. Be
sure there are no hidden electrical wires or other items behind the
point where you plan to mount the display unit.
2. Unpack the flush mounting kit. A mounting template is supplied with
the kit. Tape this over the selected location on the panel and trace
around the opening for the display unit. Also mark the locations of
the holes for the screws.
3. Make the cutout for the display. Drill two 1/2" (13 mm) pilot holes at
the two corners shown at the edges of the cutout area.
4. Cut along the outline of the opening with a small saw.
5. Separate the display unit from the mounting bracket. Set the display
unit into the opening and check the fit.
6. Attach the two flush mount handles using the knobs.
7. Lower the handles to tighten and hold the unit in place.

Fig. 2-14 Flush-Mount Installation

8. Once the DC wiring is complete, finish the installation. A suitable
sealant may be used between the gasket and the console to prevent
moisture from entering the console. Fit the display into the cutout
again. From the rear, screw the nuts securely onto the threaded
studs to hold the unit in place.
L750 Fishfinder: Installation and Operation Handbook
9mm (0.35 in)
maximum