Table of Contents
Advertisement
Mounting the Display Unit – Flush Mount
In order to do this installation, you will need the optional flush mounting kit
(part no. M99-138). See Fig. 2-12.
1.
Select a mounting location on the dashboard or control panel.
Choose a clear, flat area at least 7" x 7" (180 mm x 180 mm). Be
sure you will also have at least 6" (152 mm) of clearance behind the
area where the display unit will be mounted. It is a good idea to drill
a small pilot hole in the center of the mounting area. Be sure there
are no hidden electrical wires or other items behind the point where
you plan to mount the display unit.
2.
A mounting template is supplied with the flush mounting kit. Tape this
over the selected location on the panel and trace around the edges.
3.
Make the cutout for the display. Drill a series of 1/2" (13 mm) holes at
the points shown around the edges of the cutout area.
4.
Drill the two small holes for the threaded studs as shown on the
mounting template. Use a 7/32" (5.5 mm) drill bit.
5.
Remove the template and draw straight lines between the 1/2" holes.
Cut along each of the lines with a small saw.
18
Fig. 2-12
Flush-mount
Installation
Installation
Hide quick links:
Advertisement
Table of Contents
