Ricoh PT3 Field Service Manual page 188

6. Appendix: Service Program Mode Tables
No.
9-30 Clear Printer Setting
9-31 Clear NIB NVRAM – System
Load Program - System
9-40
SP9-1: Output Data Print
In normal operation, an image that is sent from the computer is printed out. But with this SP mode, the image
is changed to hex data and then output on paper or to an SD card.
There are three settings:
0: Normal (Default setting)
6
1: Hex Dump
2: SD card
Hex Dump:
The image is changed to hex data, and the hex data is printed out on paper.
• This mode continues until main power is shut off.
• In some cases, there will be a large quantity of data, and many masters will be consumed to print out
the hex dump. Be careful when you use this mode.
SD Card:
The image is changed to hex data, and the hex data is transferred to an SD card.
Procedure:
1. Turn off the main switch.
2. Put the SD card in the SD card slot.
3. Turn on the main switch.
4. Set SP 9-1 to "1: SD card" and get out from the SP mode.
5. Send the data from the computer
6. The "data in" LED on the machine blinks during the data transfer, and the LED turns off when the data
transfer is finished (the transfer takes a few seconds).
7. Set SP 9-1 to "0: Normal".
50
Menu Items Default Settings
- -
- -
-