Ricoh PT3 Field Service Manual page 107

• Properly insert the edge of the cloth screen [A] on the cloth screen under the mylar [B] on the metal
screen, as shown above. Otherwise, ink will leak from the trailing edge of the master on the drum
during a long printing run.
• Make sure that the correct side ([A]: Inside, [B]: Outside) of the screen is facing up. In addition, make
sure that the stays for securing the cloth screen are positioned correctly.
• When replacing the cloth screen, spread the screen around the metal screen while pulling the stay
[C]. Adjust the stay so that it is parallel to the master clamper, then tighten the screws.
• Make sure that the cloth screen is not wrinkled while spreading it around the drum.
Drum
4
105