ASSEMBLY INSTRUCTIONS
STEP 6
Bolt the HANDLEBAR SHAFTS(69) to the MAIN FRAME(1) on both sides and securely tighten.
STEP 7
Slide the WASHER(ø16.2xø22x1.5mm)(60) onto the HANDLEBAR SHAFT(69). Slide the RIGHT
HANDLEBAR(7) onto the HANDLEBAR SHAFT(69) in approximately the center of the sliding range.
Place the PLASTIC WASHER(ø10xø18x2mm)(58) on the SHAFT on the lower end of the RIGHT
HANDLEBAR(7). Connect the right LINKAGE(8) to the RIGHT HANDLEBAR(7), then slide the RIGHT
HANDLEBAR(7) completely onto the HANDLEBAR SHAFT(69). Secure the right LINKAGE(8) with the
PLASTIC WASHER(ø10xø18x2mm)(58), WASHER(M8)(96), and NYLOCK NUT(M8x1.25)(92). Repeat
on other side.
Shaft
Shaft
10