Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
WARNING:
The SMALL CRANKS(44) require a special tool to remove once assembled. Read all of
the following ASSEMBLY INSTRUCTIONS before attaching the SMALL CRANK(44).
NOTE:
1. Align the ARROW MARK on the SMALL CRANK(44) with the WHITE MARK on the AXLE(9)
when installing the two SMALL CRANKS(44) onto the AXLE(9). Refer to inset drawing A.
2. The RIGHT FLANGE NUT(M10x1.25)(47), black color, has right hand threads and is tightened
by turning clockwise. The LEFT FLANGE NUT(M10x1.25)(46), brass color, has left hand threads
and is tightened by turning counterclockwise.
3. There is an "L" decal on the LEFT CRANK(53), and an "R" decal on the RIGHT CRANK(54).
STEP 5
To assemble the RIGHT CRANK(54), attach the SMALL CRANK(44) to the AXLE(9) with TOOTH LOCK
WASHER(M10)(45) and RIGHT FLANGE NUT(M10x1.25)(47). SECURELY TIGHTEN the RIGHT FLANGE
NUT(M10x1.25)(47) with the socket wrench. Push the CRANK CAP(48) into the SMALL CRANK(44).
CAUTION:
It is possible to assemble the LEFT CRANK(53) and the RIGHT CRANK(54) the wrong way
as shown in inset drawings B and C. The SMALL CRANK(44) on the LEFT CRANK(53) must
be assembled in the opposite direction from the right side. Refer to the below illustration. Use
the same procedure as above to assemble the LEFT CRANK(53).
White Mark
A.
Arrow Mark
L
9
B.
C.
R
Socket Wrench
Advertisement
Table of Contents
