Table of Contents
Advertisement
Informative safety provisions
•
The instruction manual must be always kept together with the device.
•
In addition to the instruction manual, local regulations covering accident prevention and pollution
control must also be observed.
• All safety and warning signs on the device must be kept in a readable condition.
Training of the users
• Only persons who have been instructed and properly trained may use the BB-86.
• All users must be fully trained with all aspects of the device including how to mount, start-up,
handle, service, and repair the BB-86.
• Beginners may only work with the BB-86 under the supervision of an experienced user.
Device- magnet and switches
• Do not manipulate the magnetic plate and do not modify the switches under any circumstances.
• Only trained users are allowed to work with the BB-86 device.
Safety provisions in the standard mode
• All protection apparatus must be absolutely functioning whenever the device is in operation.
• Before switching-on the device, the operator must make sure that nobody is exposed to any risks
when the device is started.
• The device should be checked for external damage and that it is functioning safely at least one
time during each shift.
Risks of electrical power
• Service work conducted on the electrical supply must be done by an expert (i.e. Certified
Electrician, etc.)
• Inspection of the electrical components of the device must be performed at regular intervals.
Loose connections and damaged cables/wires must be repaired immediately.
• If it is necessary to do work on electric components, a second person must be present who can
remove the power cord from the main power outlet in case of an emergency.
Especially dangerous areas
• The magnetic base of the BB-86 poses a risk of pinching fingers and hands when clamping down
on the motor block surface. Exercise caution when activating the magnet.
• The rotary cutting bit has very sharp and jagged edges and can cause severe lacerations or
others injures. Exercise caution when processing the counterbore sleeves!
• The BB-86, BB-86 Giant and BB-86 Mini have rotating machine parts which present a risk for
(long) hair, hands and fingers. Wear suitable personal safety protection equipment (e.g. hairnet,
gloves etc.).
Leaking of hazardous dust and vapours
• During the processing of the counterbore sleeve, metal dust, particles, and vapour from the cutting
oil can occur. These fine particles can irritate and injure the lungs and eyes. Wear suitable
personal safety protection equipment (e.g. safety goggles, mask etc.). Ensure sufficient
ventilation during processing. For added safety, an eyeflushing device should be available.
19 July 2023/v1.7
BB-86 | Serial-No. 865 / 0609 ©
5
(All rights reserved)
Advertisement
Table of Contents
