Mira BB-86 Mini Instruction Manual page 23

Figure 12
Figure 13
Figure 14
19 July 2023/v1.7
4. Using both hands, place the unit on top of the cleaned
set up area (the handle is positioned to left in this
example). Connect the power cord to an electrical
outlet. Figure 12
5. Place the unit slightly off center to the counterbore.
The greater distance to the center of the unit should be
on the opposite side of the handle. Figure 13
6. Move the switch to position 1. Raise the main spindle
by means of the vertical advancing mechanism until
the cutting edge is above the counterbore seat, lock
slightly. Figure 14
BB-86 | Serial-No. 865 / 0609 ©
22
(All rights reserved)