Network Settings; Network Discovery - DEVA Broadcast DB90-RX Instruction Manual

NETWORK SETTINGS

After connecting the network cable the Led 'LAN' located on the rear panel must be ON or
flashing. The next and most important step for configuration is the adjustment procedure of the
Network Communication. The settings shown below are Default Network Settings:
DHCP Enabled
IP Assigned by DHCP
Mask Assigned by DHCP
Gateway Assigned by DHCP
DNS Assigned by DHCP
HTTP Port 80

NETWORK DISCOVERY

This is a network setting that defines whether your computer can see (find) other computers and
devices on the network and whether other computers on the network can see your computer. By
default, Windows Firewall blocks network discovery but you can enable it.
1. Open Advanced sharing settings by clicking the Start button, and then on "Control Panel".
In the search box, type "network", click "Network and Sharing Center", and then, in the left
pane click "Change advanced sharing settings";
2. Select your current network profile;
3. Click "Turn on network discovery", and then click save changes.
NOTE: If you're prompted for an administrator password or confirmation, type the password,
provide confirmation or contact your system administrator.
If you have already enabled this function on your computer DB90-RX will be automatically
added to the Device list section. The device will be ready for usage and no additional adjustments
will be required except user name and password.
NOTE:
If the port is different than the default one (80), it is necessary to specify it, for example:
http://192.168.1.2:9000
ATTENTION:
visible outside your local network, thus the device may be accessed only within that network.
Consult with your network administrator for the appropriate IP settings.
Depending on Internet Protocol Settings, the assigned IP address may not be
65 Aleksandar Stamboliyski Str., 8000 Bourgas, Bulgaria
Tel: +359 56 820027, Fax: +359 56 836700
E-mail: office@devabroadcast.com ,Web: www.devabroadcast.com
- 14 -