Getting Started; Connection - DEVA Broadcast DB90-RX Instruction Manual

Ip audio decoder

Hide thumbs Also See for DB90-RX:

Table of Contents

In order for the normal operation of the DB90-RX to be guaranteed, you will need fulfill the

following conditions:

1. Standard Ethernet 10/100M connection;

2. Correctly assigned Network configuration and device settings.

To make sure that all the conditions are fulfilled please, follow the instructions below.

1. Install the unit on its operation place;

2. Using the provided power cable, connect the unit to the power supply network;

3. Connect the antenna cable to the RF antenna input connector located on the rear panel of

the device;

4. Connect the DB90-RX to the TCP/IP network using direct network cable;

IF GSM OPTION IS SUPPORTED

optional GSM modem. In order for better GSM network coverage to be achieved, please

select proper place for the GSM antenna.

NOTE:

The GSM antenna must be installed far enough from the monitoring devices. The

GSM modem radiates RF signal that may cause spurious emissions that will may interfere with the

accuracy of the measurements.

E-mail: office@devabroadcast.com ,Web: www.devabroadcast.com

Getting Started

- Using the connection cable provided, connect the

- 13 -

65 Aleksandar Stamboliyski Str., 8000 Bourgas, Bulgaria

Tel: +359 56 820027, Fax: +359 56 836700

Table of Contents