Rangemaster 110 Electric User Manual page 26

WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
15. To Remove Fan Oven Inner Back.
Open RH oven door and remove the screws and
washers securing the inner back to the back of the oven.
Carefully lift away the inner back. Reassemble in reverse
order making sure that the 4 screws and washers are
fully tightened.
16. To Change Fan in Oven.
Disconnect from electricity supply.
Pull cooker forward to gain access to the rear. Remove
screws securing the electric cover to the back sheet and
remove cover. Disconnect the 3 terminals connected to
the fan noting their position. Remove oven inner back
(see 15).
Hold the fan blade and remove the centre nut (left hand
thread) 2 brass washers, fan blade and circlip. Unscrew
fan retaining nuts and washers (3 off each) and lift the
fan away from the rear of the cooker. Fit new fan and
reassemble in reverse order. Check operation of oven.
17. To Remove Fan Oven Element.
Disconnect from electricity supply.
Pull cooker forward to gain access to the rear. Remove
screws securing the electric cover to the back sheet and
remove cover. Disconnect the 3 terminals connected
to the element noting their position. Remove oven
inner back (see 15). Remove 2 screws from the top
of the element and 1 from the bottom of the element
in side the oven. Lift out carefully, refi t new element,
reassemble in reverse order. Check operation of oven.
18. To Remove Grill Element.
Disconnect from electricity supply.
Pull cooker forward to gain access to the rear. Remove
screws securing the electric cover to the back sheet and
remove cover. Remove the 4 terminals connected to the
elements noting their position. Remove grill pan from
grill chamber. From inside grill compartment remove
enamelled front shield from grill roof, 2 screws and
washers. Remove 2 screws and washers securing the
grill element front support. Remove 1 screw from each
of the grill elements and withdraw grill elements from
grill chamber. Fit new elements, reassemble in reverse
order. Check operation of grill.
19. To Remove LH Oven Elements.
Disconnect from electricity supply.
Pull cooker forward to gain access to the rear. Remove
screws securing the electric cover to the back sheet and
remove cover. Remove the 4 terminals connected to the
top element noting their position. Remove 2 screws and
washers securing the bottom element cover. Remove
the 2 terminals connected to the bottom element noting
their position. Remove 2 screws and washer from the
bottom element support. Remove 2 screws and washer
from the element bracket and withdraw the element. Fit
new element, reassemble in reverse order. Open LH
oven door and remove 2 screws and washers securing
the top element heat shield. Remove 2 screws and
washers from the top element bracket and withdraw.
Fit new element, reassemble in reverse order. Check
operation of oven.
20. To change oven light bulb.
Disconnect from electricity supply.
LH Oven
Remove the oven furniture and side linings.
Remove the oven rear liner.
RH Oven
Remove the oven inner back (see 15). The
oven light cover is now accessible. Unscrew
the cover.
Unscrew the bulb.
Fit an Edison screw fi tting 15w 240v lamp, FOR OVENS.
It must be a special bulb, heat resistant to 300°C.
26