Table of Contents
Advertisement
WARNINGS:
Remember that the gas inlet union on the
appliance is a 1/2" gas parallel male type in
compliance with ISO 228-1 standards. The
installer must ensure that the gas supply pipe
is never able to touch moveable parts of the
built-in cabinet (e.g. drawers). Furthermore, it
must not pass through compartments that
could be used for storage purposes. When
using a flexible hose, it is essential to comply
with the following instructions:
- No part of the pipe must be able to touch
parts the temperature of which exceeds
75ºC
- The pipe must not be pulled or twisted,
throttled or tightly bent.
INSTALLATION
- It must not come into contact with sharp
edges or corners.
- It must be easy to inspect the entire pipe
length in order to check its state of wear.
- The pipe must be replaced within the date
stamped on the pipe itself.
- The appliance complies with the provisions
of
90/396 + 93/68 regarding gas safety.
- Flexible hoses for LP Gas should be suitable
for LPG, capable of 50 mbar pressure, 70°C
temperature rise and carry a red stripe,
band or label. If in doubt contact, your
supplier.
8
the
following
EEC
Directives:
Advertisement
Table of Contents
