Table of Contents
Advertisement
TECHNICAL INFORMATION FOR
THE INSTALLER
This appliance shall be installed in
accordance with the regulations in force and
only in a well-ventilated space. Read the
instructions before installing or using this
appliance.
In the UK the regulations and standards are
as follows: -
In your own interest and that of safety, it is
law that all gas appliances be installed by
competent persons. CORGI registered
installers undertake to work to safe and
satisfactory standards. Failure to install the
appliance correctly could invalidate any
warranty or liability claims and lead to
prosecution.
3) INSTALLING THE HOTPLATE
Check that the appliance is in a good condition
after having removed the packaging. In case of
doubt, do not use the appliance and contact
qualified personnel.
Never leave the packaging materials
(cardboard, bags, polystyrene foam, nails,
etc.) within children's reach since they could
become potential sources of danger.
The size of the opening required in the top of the
cabinet is shown in fig. 7 and the accompanying
table. Always comply with the installation
FIG. 7
FIG. 8
INSTALLATION
dimensions (see fig. 7 – 8).
The appliance is class 3 and should therefore
installed built-in as detailed in these
instructions.
4) FIXING THE HOTPLATE
The hotplate has a special seal that prevents
liquid from infiltrating into the cabinet. Carefully
follow these instructions in order to correctly
apply this seal:
- Detach the seals from their backing, checking
that the transparent protection still adheres to the
seal itself.
- Turn the hotplate over and correctly position seal
"E" (fig. 9) under the edge of the hotplate itself, so
that the outer side of the seal perfectly matches
the outer edge of the hotplate. The ends of the
strips must fit together without overlapping.
- Evenly and securely fix the seal to the hotplate,
pressing it in place with the fingers.
- Fix the hotplate to the worktop with the brackets
"S". Ensure the tag fits into the hole "H" on the
hotplate base, then tighten the screw "F" until it is
locked to the worktop (fig. 10).
- Above hotplate level the sidewalls (left or right)
must not be closer than the minimum dimensions
show in the fig. and table.
COMPLY WITH THE DIMENSIONS
Four burner hotplate
Five burner hotplate 553 473 67.5 59.5 175 min.
FIG. 9
6
(mm)
A
B
C
D
553 473 67.5 59.5 100 min.
FIG. 10
E
Advertisement
Table of Contents
