Table of Contents
Advertisement
7.2.2 Channel Scan
Use pq to select Installation, press OK or u to advance.
Use pq to select Channel Scan and press OK to enter.
Use tu to toggle between available scan modes: By Channel and By Frequency.
If By Channel is selected, use the cursor buttons to select Scan Band and Channel No. If By
Frequency is selected, use the cursor buttons to select Frequency and Bandwidth. Highlight
Search and press OK to start scanning. Newly found channels will be added to the channel list.
7.2.3 Antenna Power
Use pq to select Installation, press OK or u to advance.
Use pq to select Antenna Power and press OK to enter.
Set to On if you use an active antenna.
Select Off for passive antennas.
When set to On, 5 V will be present on the ANT IN connector of the receiver.
Press EXIT to leave the Antenna Power menu.
7.2.4 LCN (Logical Channel Numbering)
If LCN (Logical Channel Numbering) is activated and an LCN signal is provided by the operator,
channels will be stored in an operator defined order. Set LCN to On to activate operator defined
channel numbering or Off to store channels in found order. This function only applies when a
new channel search is performed.
7.3 System Setup
This menu allows you to manage the system settings of your receiver. It consists of the following
sub-menus: Language, TV System, Local Time Setting, Timer Setting, Parental Lock, OSD Setting
and Auto Standby.
Press pq to highlight the menu of choice and press OK advance to the next screen. Use pq
to move the highlight to the setting of choice. Values can be changed with tu. Press EXIT to
leave.
7.3.1 Language
This menu allows you to set up your language preferences.
Language:
First Audio:
Second Audio:
Subtitle Language :
Teletext:
Subtitle:
* Availability of DVB/HoH subtitles depends on the broadcast. If such subtitles are not supported, then most likely
subtitles can be activated via Teletext if available.
14
Use tu to select the language for the On Screen Display.
Use tu to select Audio language.
Use tu to select a language that will be played when the language
selected at First Audio isn't available.
Use tu to select the preferred subtitle language.
Use tu to select the preferred Teletext language (when available).
Use tu to select the preferred subtitle type to be displayed
automatically. Select Normal, Hard of Hearing or Off*
Advertisement
Table of Contents
