Installing An Interface Card - HPE JH323A Installation Manual

This section uses the LSWM2SP2PM interface card as an example to describe the procedures for
installing and removing an interface card.

Installing an interface card

Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
1.
Remove the filler panel from the target interface card slot as follows:
2.
a. Remove the screw on the filler panel.
b. Use a flathead screwdriver to remove the filler panel.
Keep the removed filler panel for future use.
Figure 31 Removing the filler panel over an interface card slot
Unpack the interface card.
3.
Perform the following steps to install the interface card:
4.
a. Rotate rightward the ejector lever on the interface card.
b. Gently push the interface card into the slot along the guide rails until the interface card has
good contact with the chassis.
c. Rotate leftward the ejector lever.
d. Use a Phillips screwdriver to tighten the captive screw on the front panel to secure the
interface card in the slot.
25