Maintenance And Troubleshooting - Gold's Gym CYCLE TRAINER 400 Ri User Manual

MAINTENANCE AND TROUBLESHOOTING

MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the exercise bike is used.
Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild soap. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
CONSOLE TROUBLESHOOTING
The console requires activation. If you have not
activated the console, see assembly step 15 on
page 14.
Most console problems are the result of low batteries.
To replace the batteries, see assembly step 7 on
page 10.
If the handgrip heart rate monitor does not function
properly, see step 5 on page 18.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed switch, you must remove the rear
and front shield covers as described below.
See assembly step 5 on page 9. Using a standard
screwdriver, release the tabs along the bottom edges
of the Rear and Front Shield Covers (9, 19), remove
the two M4 x 12mm Screws (61), and then remove the
Rear and Front Shield Covers.
Next, locate the Reed Switch (21). Turn the Pulley (13)
until a Pulley Magnet (16) is aligned with the Reed
Switch.
16
21
63
Next, slightly loosen the indicated M4.5 x 12mm Flange
Screws (63). Slide the Reed Switch (21) slightly closer
to or away from the Pulley Magnet (16), and then
retighten the Flange Screws. Then, turn the Pulley (13)
for a moment. Repeat these actions until the console
displays correct feedback.
When the reed switch is correctly adjusted, reattach
the rear and front shield covers.
23
13