Maintenance And Troubleshooting; Battery Replacement; Level Exercise Cycle; Adjust Reed Switch - Gold's Gym GGEX61607.0 User Manual

MAINTENANCE AND TROUBLESHOOTING

Inspect and tighten all parts of the exercise cycle reg-
ularly. Replace any worn parts immediately.
To clean the exercise cycle, use a damp cloth and a
small amount of mild detergent. IMPORTANT: To
avoid damage to the console, keep liquids away
from the console and keep the console out of
direct sunlight.

BATTERY REPLACEMENT

If the console display becomes dim, the batteries
should be replaced; most console problems are the
result of low batteries. To replace the batteries, see
assembly step 5 on page 7.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, the left side shield must be removed.
Turn the Crank (21) to the position shown. Using an
adjustable wrench, turn the Left Pedal (24) clockwise
and remove it. Next, remove the indicated M4 x 25mm
Screws (42) and the indicated M4 x 16mm Screws
(49). Then, carefully remove the Left Side Shield (17).
49
21
42
24
49
42
49
42
42
17
Next, locate the Reed Switch (43). Turn the Crank (21)
until the Magnet (38) is aligned with the Reed Switch.
Loosen, but do not remove, the indicated M4 x 16mm
Screw (49). Slide the Reed Switch slightly closer to or
away from the Magnet, and then retighten the Screw.
Turn the Crank for a moment. Repeat until the console
displays correct feedback. When the Reed Switch is
correctly adjusted, reattach the left side shield and the
left pedal.
38
43
49
21
HOW TO LEVEL THE EXERCISE CYCLE
If the exercise cycle rocks on your floor during use,
see HOW TO LEVEL THE EXERCISE CYCLE on
page 10.
15